Installation Instructions

nanoLTE E61 AP Hardware Installation Troubleshooting
NANO_INST_43325 v205_0.6 for N4G_2.5 © ip.access Limited 2019 Page 30
5.3 Factory Reset
First ensure that all other possibilities have been explored and eliminated before trying to
Factory Reset the AP.
A factory reset will clear the AP’s configuration, for example as supplied to the AP by the
NOS (or TR-069 ACS if the NOS is not used). Hence the AP will be reset to the following
configuration after a factory reset:
• Factory configuration data that cannot be removed, which includes:
• The AP’s Equipment ID (EID)
• The FQDN for the ip.access NTP services hosted by ntp.org
• The FQDN of the primary ip.access CRL mirror server
5.3.1 E61 AP Factory Reset
1) Press and hold the Reset switch.
Ensure that any implement used to press the button will not cause a static
discharge that may damage components on the board.
2) Hold the Reset button for at least 5 seconds, then release the button and the AP
will perform its Factory Reset.
If the Reset Switch is pressed for less than 5 seconds, this will only reboot the AP.
3) The Service LED blinks fast (50ms on, 50ms off) until the factory reset
commences, then it blinks slowly (50ms on, 200ms off). When the factory restore
process is complete, the LED extinguishes and the AP automatically reboots.