Installation Instructions

nanoLTE E61 AP Hardware Installation nanoLTE E61 AP Hardware Installation
NANO_INST_43325 v205_0.6 for N4G_2.5 © ip.access Limited 2019 Page 24
4.2.2 Optional PoE+ Injectors
The AP can be up to 100m from the switch/gateway to the backhaul, but allow
approximately 0.1m for routing through the injectors. The injectors can be positioned
anywhere on this cable run. Hence the injectors can be at the most convenient point for
providing power, without restricting the location of the AP.
The injectors take a direct mains input using the supplied mains cable. Use a CAT5
Ethernet cable that is capable of carrying PoE+ from each injector to the AP.
4.2.3 PoE+ Switch
In this case, the PoE+ switch is a third-party item. The cable run from the switch to the AP
can be a full 100m.
A PoE+ switch is typically used if there are multiple APs on site and/or there is other
equipment that can take advantage of PoE+.
4.2.4 GPS Source
The E61 AP includes an MCX connector for optionally using a GPS source for frequency
discipline.
The E61 AP does not have an internal GPS antenna. Hence, to use GPS for frequency
discipline, an external source must be provided, which can be a dedicated GPS antenna or
an equivalent source such as a distributed GPS system.
PoE+ Injector
PoE+
Mains
Input
Maximum total cable length between nearest
switch/gateway and AP is 100m
LAN Cable to nearest
switch/gateway
E61 AP
Switch/Router
Backhaul
Network
LAN Cable carrying PoE+
(max 100m to the PoE+ switch/router)
E61 AP
PoE+ Switch/Router
Backhaul
Network