Installation Instructions

nanoLTE E61 AP Hardware Installation nanoLTE E61 AP Commissioning
NANO_INST_43325 v205_0.6 for N4G_2.5 © ip.access Limited 2019 Page 19
3.6 Configure the Connection to the NOS Server
3.6.1 Static IP Configuration
Obtaining an IP address with DHCP is recommended for the E61 AP, and this is selected
by default. Only execute this section if static IP configuration is needed. Do this first.
11) If static IP is required, click the Change button next to the Address Type box.
12) Edit the IP Address, Subnet Mask, Default Gateway and DNS Server Address
parameters as needed.
3.6.2 Configure IPsec
When commissioning an LTE AP with the web page, IPsec is disabled by default.
Note: If IPsec is not required, also ensure that the LTE AP is pre-provisioned in the NOS with
IPsec turned off in the AP configuration stored in the NOS.
If IPsec is required, update the configuration as follows:
1) Click the Change button next to the IPsec Enabled box. The IPsec parameters
become available.
2) Enter the address for the IPSec Gateway and the Traffic Selector addresses and
subnet masks.
ALERT: If the IPsec connection is towards an ACME SeGW the Traffic Selector
IP Addresses and Subnet Masks must all be left as 0.0.0.0.