Installation Instructions

nanoLTE E61 AP Hardware Installation nanoLTE E61 AP Commissioning
NANO_INST_43325 v205_0.6 for N4G_2.5 © ip.access Limited 2019 Page 18
2) Near the top of the main page, click the Update button next to the current software
version. The web page for downloading software will be shown. This also provides
full details about the current software installed on the LTE AP. For example:
3) In the SDP File URL text box, enter the URL for the SDP file stored on the
commissioning terminal. For example:
http://192.168.0.2/webservername/440K007_<ver>_signed.sdp
Where <ver> is the actual build version of the required software package.
4) Click Begin Download.
5) Wait about a minute for the download to take place.
6) To restart the LTE AP from the new software just downloaded, briefly press the
corresponding reset button on the back of the AP.
7) Once the LTE AP has started, repeat the procedure in section 3.4 to perform a
factory reset and access the login prompt to login again with the commissioning
user name and password.
8) Click the SW Download link on the left.
9) Inspect the software version information to verify that the LTE AP has booted from
the downloaded software.
10) To ensure the standby bank also has the latest software version, repeat the
software download, but do not restart the LTE AP. It is not necessary to restart the
LTE AP once it is already running the updated software.
This ensures the LTE AP does not have old software on the standby bank. Hence,
if the LTE AP is commanded to switch banks, it will run up-to-date software.