Installation Instructions
Table Of Contents
- nanoLTE E61 AP Hardware Installation
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 3 nanoLTE E61 AP Commissioning
- 3.1 Requirements for Commissioning with the Web Page
- 3.2 Redirector First Contact and NTP Synchronisation for Software Update
- 3.3 Configure a Commissioning Terminal
- 3.4 Access the Commissioning Web Page for the LTE AP
- 3.5 Optional - Software Download
- 3.6 Configure the Connection to the NOS Server
- 3.7 Commissioning Complete
- 4 nanoLTE E61 AP Hardware Installation
- 5 Troubleshooting
- 6 AP and PSU Regulatory Information
nanoLTE E61 AP Hardware Installation Installation Overview and Requirements
NANO_INST_43325 v205_0.6 for N4G_2.5 © ip.access Limited 2019 Page 7
2.3.4 nanoLTE E61 AP Power Requirements
Maximum expected power consumption:
• Approx 16W (Rated +12V on the DC input)
The E61 AP uses power from a suitable DC source (+12V, 1.8A rated centre positive
2.1mm jack). Use the supplied mains adaptor only.
Alternatively, provide PoE+ via the Ethernet connection. The mains power adaptor is not
required in this case.
PSU
The following 12V PSU, rated up to 30W, is included in the box with the E61 AP:
There must be a suitable mains power supply point for plugging in the power adapter. The
lead on the PSU is 1.5m long, hence the power supply point must be within 1.5m of the AP.
Note: This PSU has a maximum ambient operating temperature rating of 40°C. An alternative
PSU, part number PSAA30R-050(MOT), is available for deployments where the ambient
temperature is above 40°C. If there is a requirement to obtain the alternative PSU, contact
an ip.access representative.