Technical data

10
8.2 No or low water fl ow in spite of open water intake
Cause: Mains pressure too low.
Troubleshooting: Check mains pressure. If the fault continues, check the fi lter system and fi lter
cartridge and change if necessary.
Cause: Filter head not mounted in direction of fl ow.
Troubleshooting: Dismantle fi lter head and install in direction of fl ow (Chapter 4).
8.3 Leak
Cause: Screwed connections not fi tted correctly.
Troubleshooting: Check mains pressure. Check all screwed connections and mount according to
Chapter 4. If the fault continues, exchange fi lter system.
9 Technical Data
PURITY C Filter System with Filter Cartridge
PURITY C50
Quell ST
PURITY C150
Quell ST
PURITY C300
Quell ST
Operating pressure 2 bar – max. 8.6 bar (29 psi – max. 125 psi)
Water intake temperature 4°C – 30°C (39°F – 86°F)
Ambient temperature during operation 4°C – 30°C (39°F – 86°F)
storage/transport –20°C to 50°C (–4°F – 122°F)
Nominal fl ow 60 l/h (15.9 US gallons/h)
Pressure loss at nominal fl ow 0.25 bar (3.6 psi)
Empty fi lter cartridge volume 1.0 l (0.3 US gallons) 1.9 l (0.5 US gallons) 2.9 l (0.8 US gallons)
Weight (dry/wet) 1.0 /1.4 kg (2.2/3.1 lb) 1.7/2.5 kg (3.7/5.5 lb) 2.7/3.9 kg (6.0/ 8.6 lb)
Dimensions of fi lter system (fi lter head with fi lter
cartridge) (Width/Depth/Height)
115/105/265 mm
(4.53/4.13/10.42 inch)
115/105/421 mm
(4.53/4.13/16.57 inch)
122.5 /120 / 475.5 mm
(4.82/4.72/18.72 inch)
Dimensions (fi lter cartridge)
(Width/Depth/Height)
105/105/258,5 mm
(4.13/4.13/10.18 inch)
105/105/414,5 mm
(4.13/4.13/16.32 inch)
120 /120/469 mm
(4.72/4.72/18.46 inch)
Installed dimensions (vertical installation with wall
mounting) (Width/Depth/Height)
130/119.5/265 mm
(5.12/4.70/10.43 inch)
130/119.5/421 mm
(5.12/4.70/16.57 inch)
130/127/475.5 mm
(5.12/5.00/18.72 inch)
In addition to the accessories, the bending radii of the intake and outlet hose must be considered in addition to the dimensions of
the complete system, depending on the installation orientation.
Operating position Horizontal or vertical
Inlet connection 3/ 8" – 18 NPT
Outlet connection 3/ 8" – 18 NPT
System Tested and Certifi ed by NSF International against NSF/ANSI
Standard 42 for the reduction of Chlorine taste and odor.
The PURITY C Water Filter System is used to remove carbonate hardness (temporary hardness/
alkalinity)* from drinking water to prevent limescale deposits in downstream appliances. Do not
use with water that is microbiologically unsafe or of unknown quality without adequate disinfection
before or after the system. Use cold water only. All of the materials used are safe for contact with
drinking water. Observe relevant regulations. Read the manual prior to use.
* Not performance tested or certifi ed by NSF.
1001411-001_1001426-001.indd Abs1:101001411-001_1001426-001.indd Abs1:10 02.03.2009 16:41:33 Uhr02.03.2009 16:41:33 Uhr