Manual

Swedish Mauser Rifle Manual

1999 Anders J.

9. Assembly

1. Assemble the floor plate, magazine spring and follower and replace in the magazine.

Press the floor plate forward until it snaps in place.

2. Attach the firing pin spring to the firing pin.

3. Assembly the bolt cover and safety. Assemble the bolt cover so that the numbers on

the firing pin faces the safety.

4. Place the firing pin against a non-damaging surface. Place the thumb over the safety

(in its middle position) and press the bolt cover downwards as far as it will go.

5. Slide the cocking piece over the firing pin and turn it a ¼ turn so that the notch on the

cocking piece is aligned with the cut in the bolt cover.

6. Ease up the bolt cover.

7. Screw the bolt together.

8. Push the bolt stop to the left and insert the bolt in the receiver, push down the

follower and push the bolt forward and close the bolt.

9. Safety off.

10. Open bolt.

11. Press the trigger and push the bolt forward with the firing pin uncocked. (See picture

below).

12. Close bolt.

13. Safety on.