User manual

AIMB-562 KIOSK User Manual 42
! Video Off Method [DPMS]
This item allows user to determine the manner is which the monitor is blanked.
V/H SYNC+Blank This option will cause system to turn off vertical and horizontal syn-
chronization ports and write blanks to the video buffer.
Blank Screen This option only writes blanks to the video buffer.
DPMS Initial display power management signaling.
! Video Off In Suspend [Yes]
This item allows user to turn off video when system is in suspend mode.
! Suspend Type [Stop Grant]
This item allows user to determine the suspend type.
! Modem use IRQ [3]
This item allows user to determine which IRQ the MODEM can use.
! Suspend Mode [Disabled]
This item allows user to set a delay time. If system inactivity exceeds the delay
time, all devices except the CPU will be shut off.
! Soft-Off by PWR-BTTN [Instant-Off]
This item allows user to define function of power button.
Instant-Off Pressing power button initiates instant power off.
Delay 4 Sec Press power button for four seconds to initiate power off.
! PowerOn by LAN [Enabled]
This item allows user to power on the system via LAN. The choices are
“Enabled” and “Disabled”.
! PowerOn by Modem [Enabled]
This item allows user to power on the system by Modem. The choices are
“Enabled” and “Disabled”.
! USB KB Wake_Up From S3 [Disabled]
This item allows user to allow a USB keyboard to wake up the system from S3
suspend. Options: Enabled or Disabled.
! PowerOn by Alarm [Disabled]
The choices are “Enabled” and “Disabled”. If enabled, the fields that follow indi-
cate dates and times of alarm settings.
! Primary IDE 0 (1) and Secondary IDE 0 (1) [Disabled]
When Enabled, the system will resume from suspend mode if Primary IDE 0 (1)
or Secondary IDE 0 (1) becomes active. The choices are “Enabled” and “Dis
-
abled”.
! FDD, COM, LPT PORT [Disabled]
When Enabled, the system will resume from suspend mode if the FDD inter-
face, COM port, or LPT port becomes active. The choices are ”Enabled” and
“Disabled”.
! PCI PIRQ [A-D]# [Disabled]
When Enabled, the system resumes from suspend mode if an interrupt occurs.
The choices are “Enabled” and “Disabled”.
! PWRON After PWR-Fail [Former-Sts]
Use this to set up the system after power failure. The “Off” setting keeps the
system powered off after power failure, the “On” setting boots up the system
after failure, and the “Former-Sts” returns the system to the status before power
failure.