User manual

9 AIMB-562 KIOSK User Manual
Chapter 1 General Information
1.8.6 COM3/7 RS 232/422/485 mode selector (JSETCOM3456/78910)
Users can use JSETCOM3456/78910 to select among RS 232/422/485 modes for
COM3 and COM7. The default setting is RS 232.
RS232 RS422 RS485
*RS232 (5-6) + (7-9) + (8-10) + (13-15) + (14-16) closed
RS422 (3-4) + (9-11) + (10-12) + (15-17) + (16-18) closed
RS-485 (1-2) + (9-11) + (10-12) + (15-17) + (16-18) closed
*: Default
1.8.7 LVDS Power Jumper Connector(JLVDSPWR1)
JLVDSPWR1 is the jumper for either 3.3 V or 5 V output when connector to LCD
panel.
connect to 3.3 V 1-2 pin closed
connect to 5 V 2-3 pin closed
1.9 System Memory
The AIMB-562 KIOSK has two sockets for 240-pin SODIMMx2.
All these sockets use 1.8 V unbuffered double data rate synchronous DRAMs (DDR2
SDRAM). They are available in capacities of 512 and 1024 MB. The sockets can be
filled in any combination with DIMMs of any size, giving a total memory size between
512 MB and 2 GB. AIMB-562 KIOSK does NOT support ECC (error checking and
correction).
1.10 Memory Installation Procedures
To install SODIMMs, first make sure the two handles of the SODIMM socket are in
the “open” position. i.e. The handles lean outward. Slowly slide the SODIMM module
along the plastic guides on both ends of the socket. Then press the SODIMM module
right down into the socket, until you hear a click. This is when the two handles have
Table 1.5: COM3456/78910 RS 232/422/485 mode selector
(JSETCOM3456/78910)
Function Jumper Setting
Table 1.6: LVDS power jumper selectior
Function Jumper Setting