User`s manual

General I/O
Two IDE connectors (Bus Master with Enhanced) to support Ultra DMA 33/ATA66/ATA100
IDE drives and ATAPI compliant devices
One Floppy Controller for up to two drives
Two UART connectors, one on the rear I/O panel, the other internal connector is on the board.
One 25pin ECP/EPP Parallel Port
One PS/2 Keyboard
One PS/2 Mouse
One internal WOL connector
BIOS
Phoenix BIOS
4Mb Flash ROM (FWH)
Flash write Protection for BIOS
Support ACPI S1, S3 and S4
Auto configuration for IDE hard disk types
Multiple boot options
System Management
Winbond® hardware monitor
One 3-pin CPU Fan header with fan speed detect
Two 3-pin Chassis Fan headers with fan speed detect
Three temperature sensors
Eight Voltage monitoring (Vcore, +1.5V, +3.3V, +5V, +12V, -12V, Battery, 5VSTB)
Form Factor
ATX Form Factor
ATX 12V power connectors
Stacked PS/2 Mouse/Keyboard ports; Stacked 4 USB2.0 and 10/100, GbE LAN ports
Stacked one Serial, One IEEE1394, Rear, Center/Subwoofer connectors and one Parallel ports
Approvals
FCC class B Product safety IEC60950, EN60950, CE mark 89/336/ECC(EMV) and acc. To EU
Miscellaneous
Support AC power failure
ACPI 1.1
PC2001
APM 1.2
User’s Manual 6-4
SMBIOS 2.3
BIOS boot Spec. 1.01
WfM 2.0
DMI 2.0