User`s manual

Mainboard User’s Manual
22
Power Management Setup Page
This page sets up some parameters for system power management
operation.
CMOS Setup Utility – Copyright (C) 1984 – 2001 Award Software
Power Management Setup
Item Help
ACPI Function Enabled
Power Management Press Enter
ACPI Suspend Type S1(POS)
PM Control by APM Yes
Video Off Option Suspend --> Off
Video Off Method Blank Screen
MODEM Use IRQ 3
Soft-Off by PWRBTN Delay 4 Sec
State After Power Failure Off
Keyboard Power On Disabled
Wake Up Events Press Enter
Menu Level
↑
↑↑
↑ ↓
↓↓
↓ →
→→
→ ←
←←
←
: Move Enter : Select +/-/PU/PD:Value F10: Save ESC: Exit F1:General Help
F5:Previous Values F6:BestPref. Defaults F7:Optimized Defaults
ACPI Function
Use this item to enable or disable the ACPI function.
Power Management
This item acts like a master switch for the power-
saving modes and hard disk timeouts. If this item is
set to Max Saving, power-saving modes occur after
a short timeout. If this item is set to Min Saving,
power-saving modes occur after a longer timeout. If
the item is set to User Define, you can insert your
own timeouts for the power-saving modes.
ACPI Suspend Type
This item defines how your system suspends. The
suspend mode of S1(POS) is equivalent to a
software power down. If you select the suspend
mode of S3(STR), it is a suspend to RAM - the
system shuts down with the exception of a refresh
current to the system memory.