User`s manual

Mainboard User’s Manual
8
Install Other Devices
Follow these steps below to install and connect other devices in the
system.
Floppy Disk Drive
The mainboard ships with a floppy disk drive cable that can
support one or two drives. Drives can be 3.5” or 5.25” wide, with
capacities of 360K, 720K, 1.2MB, 1.44MB, or 2.88MB.
Install your drives and connect power from the system power
supply. Use the enclosed cable to connect the drives to the floppy
disk drive header FDD1.
IDE Devices
IDE devices include hard disk drives, high-density diskette drives,
and CD-ROM or DVD-ROM drives, among others.
The mainboard ships with an IDE cable that can support one or two
IDE devices. If you connect two devices to one single cable, you
must configure one of the drives as Master and the other as Slave.
The documentation of the IDE device will tell you how to
configure the device as a Master or Slave device. The Master
device connects to the end of the cable.
Install the device(s) and connect power from the system power
supply. Use the enclosed cable to connect the device(s) to the
Primary IDE channel connector IDE1 on the mainboard.
IDE1
1
1 1
IDE2
FDD1