User`s manual

51
ECP Mode Use DMA Default: 3
When the onboard parallel port is set to ECP mode, the parallel port
has the option to use DMA 3 (default) or DMA 1.
Parallel Port EPP Type Default: EPP1.7
Sets the EPP specification. There are two options, EPP1.9 and EPP1.7.
If you make any changes to the onboard FDD controller, serial
ports or parallel ports in this setup, save the changes and turn
off the system. After powering up the system, ensure that the
changes have taken effect.
Onboard Legacy Audio Default: Enabled
Enables the onboard legacy audio function. If this item is enabled the
following items become available.
Sound Blaster Default: Disabled
Enables or disables Sound Blaster function.
SB I/O Base Address Default: 220H
This item lets you set the I/O base address for the Sound Blaster card.
SB IRQ Select Default: IRQ 5
This item lets you set the Interrupt Request (IRQ) for the Sound Blaster
card.
SB DMA Select Default: DMA 1
This item lets you select the DMA for the Sound Blaster card.
MPU-401 Default: Enabled
Use this item to enable or disable the MPU-401 (MIDI) function for the
game port.
MPU-401 I/O Address Default: 330-333H
Use this item to set the I/O address for the MPU-401 (MIDI) function.
Game Port (200-207H) Default: Enabled
This item sets the I/O address for the game port.