User`s manual
48
OnChip Modem Default: Auto
When set to Disabled, the onboard modem chip is turned off.
Memory Parity/ECC Check Default: Disabled
Enable this item to allow BIOS to perform a parity check to the POST
memory tests. Select Enabled only if the system DRAM supports parity
checking.
OnChip USB Default: Enabled
This should be enabled if your system has a USB installed on the sys-
tem board and you wish to use it.
Integrated Peripherals Option
This option displays a list of items that defines the operation of
some peripheral components on the system’s input/output ports.
CMOS Setup Utility – Copyright (C) 1984 – 2000 Award Software
Integrated Peripherals
Item Help
OnChip IDE Channel0 Enabled
OnChip IDE Channel1 Enabled
IDE Prefetch Mode Enabled
Primary Master PIO Auto
Primary Slave PIO Auto
Secondary Master PIO Auto
Secondary Slave PIO Auto
Primary Master UDMA Auto
Primary Slave UDMA Auto
Secondary Master UDMA Auto
Secondary Slave UDMA Auto
Init Display First PCI Slot
IDE HDD Block Mode Enabled
Onboard FDD Controller Enabled
Onboard Serial Port 1 Auto
Onboard Serial Port 2 Auto
UART 2 Mode Standard
x IR Function Duplex Half
x TX,RX inverting enable No, Yes
Menu Level
↑
↑↑
↑
↓
↓↓
↓
→
→→
→
←
←←
←
: Move Enter : Select +/-/PU/PD:Value: F10: Save ESC: Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
On-Chip IDE Channel 0/1 Default: Enabled
Use these items to enable or disable the PCI IDE channels that are in-
tegrated on the mainboard.