User guide

199
Creating a batch capture list
Adding clips to a batch capture list
°To define individual clips that you want to add to your batch capture list:
1 In the MediaTools dialog box, click the VTR button.
2 In the Tape I D box, type a name for the tape presently loaded in your
DV-1394 device. In the
Clip ID box, type the base clip name you’d like to be
assigned to your clips. For more information, see “How MediaTools assigns
clip names” on page 196.
3 Use the transport controls to navigate through clips on tape in your DV-1394
device.
4 Specify the In and Out points for your clip using any of the following
methods:
$ Mark or type in the In and Out points of your clip, then click Add To List
to add the clip to your clip list.
$ Mark or type in the In point of your clip, then click Add To List. MediaTools
will cue to the In point of the clip and begin playing the tape until you click
Stop and Mark Out.
$ Mark or type in the Out point of your clip, rewind your tape to where you
want your clip to start, then click
Add To List. MediaTools will use the
tape’s current position as the In point.
5 Continue adding new clips until you’ve completed your batch capture list.
6 If you want to save your batch capture list so that you can capture the clips at
a later time, right-click the clip list and choose
Save As. For more
information on saving and loading clip lists, see “Saving and loading a clip
list” on page 202.
7 When you’re ready to capture your clips, see the next section, “Capturing
clips from a batch capture list.”