User guide

165
Working with keyframes
interpolation sequence several frames before your clip starts to make the spline
calculations start earlier.
To display the area outside the clip region, right-click the track and turn off
Display Clip Region Only. Then drag the Positioner forward or backward to
scroll to the area outside the clip.
Turning interpolation on and off
As previously mentioned, a spline interpolation is set by default between
consecutive keyframes created on a track. You may, of course, choose to turn off
interpolation or change the interpolation type.
To turn off or reset interpolation, click the keyframe or a range of selected
keyframes, then on the Toolbar, click for no interpolation, for linear
interpolation, or for spline interpolation. You can also right-click the
keyframe or a range of selected keyframes, then choose
Interpolation Type >
None
, Linear, or Spline from the pop-up menu.
Depending on the location of a keyframe in a sequence and whether or not
interpolation is set, the keyframe will be represented as follows:
¦NoteNewly created keyframes will be assigned the same interpolation setting
as that of the keyframe to the immediate left on the track (or to the right if you
use the
Reverse option).
First keyframe in an interpolation sequence.
Intermediate keyframe in an interpolation sequence.
Last keyframe in an interpolation sequence.
Keyframe that is not in an interpolation sequence.
Area before clip
Clip region
Area beyond end of clip