Installation guide

Matrox Graphics Card – Installation Guide 9
Software installation
This section describes how to install Matrox software for Windows 95 and Windows NT 4.0. For
other operating systems, see “Other software”, page 14.
1 Insert the Matrox Installation CD-ROM in your CD-ROM drive – the mgasetup program
automatically starts. This setup program works with Windows 95 and Windows NT 4.0, and
detects which operating system you’re using.
2 Select the language you want to use, then click
Next
.
3 To see notes on the contents of the CD-ROM, click
View ReadMe
. To continue, click
Next
.
4 If this is a first-time installation, the setup program lists drivers that are not installed.
To begin the software installation, click
Install
.
5 Choose an installation type:
 To install the complete MGA PowerDesk
(recommended), click
Typical
.
 To customize the PowerDesk installation, click
Custom
.
If you click
Custom
, the setup program prompts you
for a destination folder and what PowerDesk options
you want to install.
After you choose, the setup program automatically
installs Matrox software and drivers. After this is
done, leave the Matrox CD-ROM in your CD-ROM
drive, then click
OK
to restart your computer and for all changes to take effect.
6 After you restart your computer, the CD-ROM setup program starts again. The main menu lists
other software you can install from the Matrox CD-ROM. To install, select an item, click
Install
,
then follow the on-screen instructions. After the installation of an item is finished, you can
return to the main menu to install another. Click
Exit
when you’re done.
If this is a first-time installation, your display is using a 640 × 480 resolution with 256 colors –
supported by most monitors. To adjust software monitor settings:
 for Windows 95, see “MGA PowerDesk for Windows 95”, page 10.
 for WindowsNT4.0, see “MGA PowerDesk for Windows NT 4.0”, page 12.