Installation guide

8 Matrox Graphics Card – Installation Guide
6
Restart your computer
7
Install the software
 If you’re using Windows 95, it reports that it
has detected new hardware when you restart:
a Click “
Driver from disk provided by
hardware manufacturer
”, then click
OK
.
b When Windows prompts you for the
software driver location, insert the Matrox
Installation CD-ROM in your CD-ROM
drive. Windows automatically starts the
CD-ROM setup program; click
Cancel
to
continue.
c Type “d:\” in the text box (where “d” is
the drive letter of your CD-ROM drive), then click
OK
.
This installs the MGA display drivers for Windows 95, but not the rest of the software
included on the Matrox CD-ROM.
d To install other software included on the Matrox CD-ROM, see “Software installation”,
page 9.
 If you’re using Windows NT 4.0, see “Software installation”, page 9.
 If you’re using Windows 3.1, Windows NT 3.51, OS/2 Warp 3.0 or 4.0, AutoCAD for DOS, or
MicroStation for DOS, see “Other software”, page 14.