Specifications

6
Known issues
• When creating a Matrox wipe transition, you may see dotted lines in your
output. To eliminate the dotted lines, apply softness to the wipe. (Ref#
33122)
• When you import DV and MPEG-2 I-frame video clips with a 720×480
resolution into a sequence that has a Matrox codec editing mode, the image
size displayed in the
Project panel and the Properties window will be
720× 486. To see the real resolution of the clip, look at the
Actual Image
Size
in the Properties window. Your clips will be processed and output
correctly when you export to file or print to tape. (Ref# 31737)
• If you use the
Customize Matrox Wipes dialog box to make changes to a
Matrox transition after it has been rendered, the changes you make will not
be updated in the Transition preview or on your Program Monitor until you
click
OK. (Ref# 39018)
• When capturing material from a tape with a bad video signal, you may
receive a Macromedia error and the captured footage will consist of blue or
black video. (Ref# 40496)
• If you have multiple Matrox wipe transitions in a sequence, and you modify
the default transition and save it, any previous wipes that were applied using
default transition settings will have the new default transition settings
applied as well. Wipe transitions that were not applied with default wipe
transition settings won’t be affected. (Ref# 41988)
• If you trim a project that contains .avi files created using a Matrox VFW
MPEG-2 I-frame or a Matrox VFW Uncompressed codec and the audio for
the files is not 48,000 kHz, those files may be offline when you open the
trimmed project. To avoid this problem, set the audio to 48,000 kHz when
creating the files. (Ref# 41996)
• If your hard drive is almost full when you capture clips, Adobe Premiere Pro
will issue a warning message and may become unresponsive after you click
OK and close the Capture panel. (Ref# 42634)
• You can’t export clips that have mono audio to a Matrox .avi file from Adobe
Premiere Pro’s
Project panel. (Ref# 42183)
• To avoid problems when capturing clips, rendering previews, or exporting
your sequence to disk, make sure that the total length of your Premiere Pro
project’s folder path name and file name is not longer than 128 characters.
(Ref# 49841).
• If you choose to capture a video source for which a video input signal is not
detected from your Matrox MXO2 hardware, the input signal may display as
blue video (instead of black video). (Ref# 50156)
• The first time you capture to a Matrox .avi file using Adobe Premiere Pro
after installing Matrox Mtx.utils, you need to configure your Matrox .avi
capture settings. To do this, choose
Project > Project Settings > General.