User guide

Chapter 8, Using Matrox MXO2 with Adobe Premiere Pro

6 Test the audio input levels by speaking into the microphone, and watch the

levels in the meters. If needed, adjust the audio level on your source device

so that the input levels are sufficiently high but not clipping.

7 Click the Record button ( ) to prepare the sequence for recording.

8 Click the Play button ( ) to start recording your voice-over.

¦NoteDuring recording, there’s a slight delay in the audio preview of your

voice-over. To mute the preview, click the

Mute Track button (M) or you can

choose to lower the track volume by dragging the

Volu m e slider.

9 Click the Stop button ( ) to stop recording. Your voice-over will be added

to the selected audio tracks as .wav files.

Setting up Matrox device control

Matrox device control lets you control any device that supports the RS-422

SMPTE time code protocol when capturing or exporting material to tape in

Adobe Premiere Pro. To use this device control, you must connect your source

device or recorder as follows:

• Matrox MXO2, MXO2 Rack, and MXO2 LE Connect the RS-422

connector on your MXO2 hardware to the serial device control port on your

source device or recorder using an RS-422 serial cable (see “MXO2 RS-422

serial connection” on page 18, “MXO2 Rack RS-422 serial connection” on

page 27, or “MXO2 LE RS-422 serial connection” on page 36).

• Matrox MXO2 Mini Matrox MXO2 Mini does not have an RS-422

connector. You can, however, use a suitable adapter to connect the serial

device control port on your source device or recorder to your computer. For a

list of supported device control adapters, see the Matrox MXO2 Support

section of our website at www.matrox.com/video/support.

°To configure your Matrox device control settings:

1 Choose Edit > Preferences > Device Control.

2 From the Devices list, select Matrox RS-422 Device Control.