User guide

44 Matrox Mura MPX Series – User Guide
2 Connect your monitors
If your monitor has a DVI connector,
connect your monitor cable directly to your
LFH-60 to dual-DVI cable.
If your monitor has an HD-15 connector,
use a DVI to HD-15 adapter included with
your product to connect your monitor cable
to your LFH-60 to dual-DVI cable.
Your Matrox card is now installed. Restart your system and install your Matrox software (see
“Installing your software”, page 46).
P690 Plus LP PCIe ×16 with a quad monitor cable
To use 4 computer monitors at a time, you need a quad-monitor cable (available from your Matrox
sales representative). This section describes how to connect your monitors to your Matrox graphics
card using a quad-monitor cable.
Monitor
connector
(HD-15)
Monitor
connector
(DVI)
LFH-60 to
dual-DVI
cable (DVI)
DVI to HD-15
adapter
Note: Monitors are numbered
consecutively based on which connector
each is attached to, starting with
connector labeled
1 .
Note: While using 4 computer monitors at a time, your monitors must support the same
monitor settings (such as display resolution and refresh rates).
WA R N I NG : Don’t change monitor connections while your computer is turned on. While
your computer is turned on, it may be using monitor settings that are specific to the current
monitor connections.
Some devices may be permanently damaged if incorrect settings are
used.
LFH-60 to dual-DVI cable