User guide

Matrox Mura MPX Series – User Guide 25
Connecting your Mura MPX-SDI card
This section describes how to connect your Matrox MPX-SDI card.
Before you begin
To avoid possible problems that could damage your monitors or prevent you from using your Matrox
product, read the following guidelines before connecting your Matrox hardware.
 Whenever you change your connection setup, make sure you’re using the correct
connectors and that all connectors are properly fastened.
 Don’t change connections while your system is turned on. Before changing connections,
make sure your system is shut down and turned off.
 Whenever you restart your computer, make sure your monitors are already turned on.
Otherwise, the software may not be able to properly detect your monitors.
Step-by-step connection setup
1 Connect your KX20 to dual-DVI
cable
Attach your KX20 to dual-DVI cable to the
connector on the bracket of your Matrox
card. Make sure the connectors are properly
fastened.
WA R N I NG : To avoid damaging the DIN
connector (1.0/2.3) on your DIN to BNC
adapter or on your card, firmly hold the
adapter, pull back the metal ring around
the DIN connector on the cable, then
carefully remove the DIN to BNC adapter.
KX20 to dual-DVI
cable (KX20)