User guide

22 Matrox Mura MPX Series – User Guide
Connecting your Mura MPX-V16 or
MPX-V8 card
This section describes how to connect a video device to the input connectors on your Mura MPX-V16
or Mura MPX-V8 card.
Before you begin
To avoid possible problems that could damage your monitors or prevent you from using your Matrox
product, read the following guidelines before connecting your Matrox graphics hardware.
 Whenever you change your connection setup, make sure you’re using the correct
connectors and that all connectors are properly fastened.
 Don’t change connections while your system is turned on. Before changing connections,
make sure your system is shut down and turned off.
Step-by-step connection setup
1 Connect your DVI to BNC cable
Attach your DVI to BNC cable to the
connector on the bracket of your Matrox
card. Make sure the connectors are properly
fastened.
DVI to BNC
cable
(Mura MPX-V16)
DVI to BNC cable
(Mura MPX-V8)