User guide

Matrox Mura MPX Series – User Guide 17
Connecting your Mura MPX-4/4,
MPX-4/2, or MPX-4/0 card
This section describes how to connect your Mura MPX-4/4, MPX-4/2, or MPX-4/0 card.
 To connect output devices (monitors), see “Connecting your output devices”, page 17.
 To connect input sources (graphics card or video device), see “Connecting your input
sources”, page 19.
Before you begin
To avoid possible problems that could damage your monitors or prevent you from using your Matrox
product, read the following guidelines before connecting your Matrox graphics hardware.
 Whenever you change your connection setup, make sure you’re using the correct
connectors and that all connectors are properly fastened.
 Whenever you restart your system, make sure your monitors are already turned on.
Otherwise, the software may not be able to properly detect your monitors.
Connecting your output devices
This section explains how to connect your output devices (monitors) to your Mura MPX-4/4,
MPX-4/2, or MPX-4/0 card.
1 Connect your KX20 to quad-DVI
cable
Mura MPX-4/4 and MPX-4/2 – Attach your
KX20 to quad-DVI cable to connector
B on
the bracket of your Matrox card. Make sure
the connectors are properly fastened.
Note: To purchase any cables or adapters not included with your Matrox product, see the
Matrox online store (shopmatrox.com
).
KX20 to quad-DVI
cable (KX20)