Specifications

18 Chapter 2: Hardware installation
In some cases, when you boot your computer, Windows’ Plug-and-Play system
will detect a new PCI card and you will be asked to assign a driver to it. At this
point, you should click on Cancel because the driver will be installed during the
installation of MIL or one of its derivatives.
Installing Matrox Meteor-II /Multi-Channel for PC/104-Plus
This section refers to the stand-alone version of Matrox Meteor-II /Multi-Channel
for PC/104-Plus. The version pre-configured for Matrox 4Sight-II is not discussed
in this manual. For more information, see Note about Matrox Meteor-II
/Multi-Channel for PC/104-Plus later in this chapter.
Use the following steps to install your Matrox Meteor-II board for PC/104-Plus:
1. Matrox Meteor-II for PC/104-Plus can operate in either a 5V or 3.3V system. In
some cases, a hole in the PC/104-Plus (PCI) connector is filled, which prevents
another PC/104-Plus board from being stacked on top. To install Matrox
Meteor-II for PC/104-Plus in a system with a specific signalling environment, a
pin must be removed. The table and diagram below indicate which pins to cut,
and their locations on the connector.
Signalling environment Pin to remove on J3 connector
5V A1
3.3V D30
PC/104-
ISA
connectors
Plus
Top view
PC/104-
expansion site
Plus
PC/104-
PCI
connector
Plus
J3
J1
DCBA
BA
1
1
30
32
J2
CD
0
19
Remove pin D30
in a 3.3 V system
Remove pin A1
ina5Vsystem