User guide

Chapter 3, Using Your Matrox MC-100 Hardware

Using the MC-100 selection modes

Matrox MC-100 offers different selection modes that allow you to quickly cycle

through different output options without having to change the MC-100 settings.

When using the MC-100 selection modes, the on-screen display (OSD) is

replaced by a heads-up display (HUD) at the bottom of the video output that

allows you to view the current selection mode setting. When cycling through the

settings in a selection mode, the corresponding options in the

OUTPUT and

3D SETTINGS menus will change automatically. For information on the

MC-100 channels, see “MC-100 channel definitions” on page 11.

¦NotePress the Select button (see “Using the OSD buttons” on page 14) to exit

the selection mode and return to the OSD menu.

°To select a selection mode:

1 Access the Matrox MC-100 OSD main menu.

2 Select SELECTION MODES from the OSD main menu.

3 Select CHANNEL SWITCHER, and then use the cycle buttons (see “Using

the OSD buttons” on page 14) to switch between channel 1 and channel 2 on

the SDI and HDMI outputs.

¦NoteSwitching between channel 1 and channel 2 is done glitch-free on SDI

outputs only.

4 Select SDI AND HDMI or HDMI ONLY, and then use the cycle buttons (see

“Using the OSD buttons” on page 14) to switch between the following

output options on the SDI and/or HDMI output.