User guide

19
Specifying your output settings
appropriate DIP switch for the OSD has been set (see “Using the
MC-100 DIP switches” on page 10).
$ SDI 1 bypass Outputs the video signal connected to input SDI 1 as is,
without any processing. The MC-100 settings do not apply for this option.
$ SDI 2 bypass Outputs the video signal connected to input SDI 2 as is,
without any processing. The MC-100 settings do not apply for this option.
$ Channel 1 Outputs the video signal on channel 1 using the current
MC-100 settings.
$ Channel 2 Outputs the video signal on channel 2 using the current
MC-100 settings.
$ 3D Outputs the channel 1 and 2 input video signals as set in the 3D
MODE
option in the 3D SETTINGS menu. The channel flip and channel
offset options are also applied to the output (see “Specifying your 3D
settings” on page 20).
$ Analysis Outputs the channel 1 and 2 input video signals as set in the
ANALYSIS MODE option in the 3D SETTINGS menu. The channel flip
and channel offset options are also applied to the output (see “Specifying
your 3D settings” on page 20).
$ Multiplex (SDI 4 and SDI 3 only) Combines the video and audio input
signals from channel 1 and channel 2 into one 3G level B video signal on
the output. The channel flip and channel offset options are also applied to
the output (see “Specifying your 3D settings” on page 20).
4 If you have an HDMI output device connected to MC-100, select
HDMI AUDIO CHANNELS, and then select the audio channels that you
want to output on HDMI. The source of the audio channels is defined by the
output setting selected in step 3.
¦NoteWhen using the 3D or Analysis output setting in step 3, or when using
a 3G level B input video signal, the HDMI audio channels are selected from
channel 1 only.
$ 1-8 Outputs audio input channels 1 to 8.
$ 9-16 Outputs audio input channels 9 to 16.