User guide

16
Chapter 3, Using Your Matrox MC-100 Hardware
Specifying your input settings
The INPUT menu allows you to select the input signal type and reference source
priority. You can also view the reference status, and the video formats for the
connected input sources.
°To set the input settings:
1 Access the Matrox MC-100 on-screen display (OSD) main menu.
2 Select INPUT from the OSD main menu.
3 Select SIGNAL TYPE, and then select the setting that corresponds to the
format of the input source connected to MC-100’s SDI input. For a list of the
supported input video formats, see “Supported input formats” on page 17.
¡ Important If you have input sources connected to SDI 1 and SDI 2, the
two video formats must be the same.
$ Standard Select this setting for progressive or interlaced SD,
progressive or interlaced HD, 3G level A, or 3G level B input signals.
$ PsF Select this setting for progressive segmented frame input signals.
$ Dual link Select this setting for dual link input signals.
$ Dual link PsF Not supported.
¦NotePsF input video signals are not supported on the HDMI output. For
SDI outputs, PsF input video signals are only supported in bypass mode (see
“Specifying your output settings” on page 18).
4 Select REFERENCE SOURCE PRIORITY to set the SDI input video signal
that will be used as the reference source when input sources are connected to
SDI 1 and SDI 2. For information on how the input signals are synchronized