User guide

Matrox Marvel – User Guide 65
3
Cause
Your sound card’s Windows software settings may be incorrect. Specifically, input or output
may be disabled, or volume levels may be too low or too high.
1
Solution
Windows 95/98 – Make sure your sound card’s Windows software settings are correct:
1 Double-click the speaker icon ( ) on the Windows taskbar.
If you
don’t see the speaker icon:
a Click Æ Settings Æ Control Panel .
b Double-click the Multimedia icon.
c Enable the “ Show volume control on the taskbar ” check box.
d Click OK .
e Double-click the speaker icon on the taskbar.
2 Click Options Æ Properties .
3 Click the Recording button, enable all check boxes in the list box, then click OK .
4 For the Line-In and/or Microphone controls, make sure the Volume slider
levels are okay (if you’re not sure, try half level), and the
Select check
boxes are enabled.
5 Click Options Æ Properties .
6 Click the Playback button, enable all check boxes in the list box, then click OK .
7 For the Master , Line and/or Wave controls, make sure the Volume sliders are at one-
quarter to one-half levels (if you’re not sure, try half level), and the
Mute check boxes
are cleared.
8 Close the dialog box.
4
Cause
The problem may be specific to the sound card you have.
1
Solution
For more information, see your sound card manual.
9x9x
Note: To access the recording settings of your sound card with Matrox
PC-VCR Remote, click
Properties () Æ Recording Æ Audio Levels .