User guide

Matrox Maevex 5100 Series – User Guide 17
7 Connect your power supply
Connect your power supply included with
your product to the
5VDC connector on
your encoder unit. While the 5V DC power
supply is connected to the unit and electrical
socket, the power LED ( ) is active (not
black).
For more information on LEDs, see
“Description of LEDs”, page 21.
After connecting your Maevex encoder unit, we recommend you validate your connection setup
before you continue (see “Validating your Maevex setup”, page 21). After you validate your setup,
install your Matrox software (see “Installing Matrox PowerStream”, page 25).
Maevex 5150 Decoder
1 Connect your video output
Connect a digital monitor to the HDMI
connector on your decoder unit.
If your digital monitor doesn’t support
HDMI output, use an HDMI adapter to
connect it to your decoder unit.
Power cable
WA R N I NG : To avoid damaging the power connector on your
unit or on your power cable when unplugging a unit, firmly hold
the power connector, pull back the connector on the cable, then
carefully remove the power cable.
Note: To use this connector, you need a
shielded HDMI cable.
If the video output of your unit uses a
display resolution higher than 720p60, we
recommend using a certified high-speed
HDMI cable.
HDMI monitor
cable