User guide

Matrox Extio Series – User Guide 55
Appendix B – Mounting your units
This section provides guidelines for mounting your Extio unit.
Mounting bracket
Your Extio unit can be mounted in a standard rack or under any hard surface (such as a desk).
 The mounting holes on the unit are 4.25 inches (10.80 cm) apart. Use four 6-32 screws.
These screws can enter the casing by a maximum of 0.25 inches (6.35 mm).
 Use a hand screwdriver to carefully tighten each screw. Make sure not to overtighten the
screws.
 If installing your unit in a rack, fasten it to the rack as per your rack’s instructions.
Mounting guidelines
To prevent damage to your Matrox hardware, read the following guidelines before mounting your
Matrox hardware:
 Make sure not to block the ventilation holes on your unit.
 Don’t stack anything directly over the unit.
 Make sure all cables and cords are slack.
 Make sure the ambient temperature doesn’t exceed the maximum recommended
temperatures. For more information, see “Environmental”, page 50.
WA R N I NG : Using screws that are longer or larger than those specified may damage
your Matrox hardware.