User guide

Specifying your administrator settings

4 Specify your Convert DVI settings. These settings will be used by your

Convert DVI when in stand-alone mode.

¦NoteOnly the settings that have been applied to your video output will be

programmed for stand-alone mode. If you make changes to the

Output or

Genlock settings, make sure to click Apply on those pages before

programming for stand-alone mode. The

Graphic overlay output option and

the

Snap to window region-of-interest option are not available in stand-alone

mode.

5 Click the Admin tab.

6 Under Stand-Alone Mode, select Input detection if you want Convert

DVI to automatically detect the output resolution of the DVI device

connected to Convert DVI’s input, and output the entire Convert DVI

desktop (DVI input) according to the selected

Output scaling mode:

$ Anamorphic Outputs the content as full-screen anamorphic video.

$ Best fit Outputs the content as either letterbox or pillarbox video,

depending on the input and output resolutions, while maintaining the

content’s aspect ratio.

This feature is especially useful when you want to connect different

resolutions to Convert DVI’s input when in stand-alone mode. When input

detection is selected, the programmed region of interest settings, and the

programmed Convert DVI desktop resolution, are ignored.

7 Under Stand-Alone Mode, click Program Current Settings to copy the

current Convert DVI settings to your Convert DVI’s internal memory. When

programming is complete,

Programmed will appear in the status window.

²Caution Do not disconnect Convert DVI’s USB cable or power cord until

the programming process is complete. Doing so may damage your Convert

DVI hardware.

Using Convert DVI in stand-alone mode

After programming your Convert DVI for stand-alone mode (see “Programming

Convert DVI for stand-alone mode” on page 46), perform the following steps to

use your Convert DVI in stand-alone mode.

1 Connect Convert DVI as shown in “Connections for using Convert DVI in

stand-alone mode” on page 17.

¦NoteEnsure that the Convert DVI USB cable is disconnected from the

Convert DVI.

2 Disconnect and then reconnect the power cord from Convert DVI. Your

Convert DVI will boot in stand-alone mode.

¦NoteYou cannot make any changes to the Convert DVI settings when

connected in stand-alone mode. To change the Convert DVI settings, Convert