User guide

81
Defining your General settings
5 If the Pulldown Method list is available, select the pulldown method you
want to be applied to your output video (
Standard 2:3 or Advanced
2:3:3:2
). You should select Advanced 2:3:3:2 only if you’ll be recording
to a DV-1394 device that supports this pulldown method. Depending on your
project’s frame rate and the current master output format, a pulldown method
may automatically be selected.
6 Under Analog Setup (NTSC), select the setup level you want for your
NTSC analog video:
$ 0 IRE Applies a setup level of 0 IRE. You should select this option only
when working with a commercial DV-1394 device that uses the Japanese
analog NTSC setup of 0 IRE. For example, if the video appears too bright
when you play back DV clips on your NTSC monitor, you can change the
setup to 0 IRE to output your DV clips at the correct brightness.
$ 7.5 IRE Applies the standard NTSC setup level of 7.5 IRE.
7 Select Allow Super White to allow the highest luminance level of your
video output to exceed the standard maximum white level. Select
Allow
Super Black
to allow the lowest luminance level of your video output to fall
below the standard black level.
¦NoteSuper white and super black should not be allowed when producing
your final video production for broadcast.
8 Under Component Gain, use the sliders to increase or decrease the Y
(luminance),
Cb (blue minus luminance), and Cr (red minus luminance) gain
of the component video output.
9 Under Advanced Settings, select the format you want for your component
video output, and make any required timing adjustments to your SDI video
output:
$ Component Output Format From this list, select the format (YUV or
RGB) that matches your component video output connections. For example,
if the component video output from X.linkHD is connected to a video
monitor using analog component Y, R-Y, and B-Y, connections, select
YUV.
$ SDI Horizontal Delay Use this slider to advance or delay the horizontal
timing of the SDI video output.
10 Click OK to save your settings and return to the Project Settings dialog
box.
Axio Installation and User Guide.book Page 81 Monday, July 14, 2008 8:00 AM