User guide

18
Chapter 2, Installing Your Matrox Axio HD or SD Hardware
Install your X.effects card
1 Make sure the power selection switch of your X.effects card is properly set
as explained in “Set the power selection switch on your X.effects card” on
page 15.
2 If you set your X.effects card to receive power from your computer’s internal
power supply, make sure the internal power supply cable is connected as
explained in “Connect the internal power supply cable to your X.effects
card” on page 16.
3 Remove the metal plate located at the back of the slot you’ll be using. Save
the screw for the mounting bracket.
4 Position your X.effects card over the slot that you’ve chosen and push the
card firmly and evenly until it’s fully seated in the slot.
5 Using the fasten screw you removed in step 3, secure your X.effect card’s
bracket to the computer frame.
6 If you’re using your computer’s internal power supply as an additional power
source for your X.effects card, connect the male end of the internal power
supply cable to a free outlet of your computer’s internal power supply.
¦NoteWhen you’ve completed the installation of your Axio hardware and
turned on your computer, the LED display on the backplate of your X.effects
card will light up to indicate that the internal power supply is properly
connected.
7 Replace your computer’s cover.
Axio Installation and User Guide.book Page 18 Monday, July 14, 2008 8:00 AM