User guide

103
Defining your Capture settings
saved to a single stereo .wav file (any other channels will be ignored). When
Axio saves the .wav file of an audio-only capture, it does not assign the
.Stereo.wav suffix to the filename.
8 Click OK to save your settings and return to the Project Settings dialog
box.
Monitoring audio levels for capture
If you select
Show VU meters on the Audio Capture Settings page, each
time you configure your Matrox Axio capture settings or open the
Capture panel
to start a capture in Adobe Premiere Pro, VU meters will be displayed to let you
monitor the levels of your currently selected audio input source.
As you play your audio source, the color of the input level is green at or below
–12 dBSF, yellow between –12 and –6 dBFS, and red above –6 dBFS. The
clipping detectors will “light up” (become red) whenever audio clipping occurs.
The peak level indicators are thin lines that show the highest level recently
reached. These indicators will show the peak level for about two seconds or until
a higher peak level is reached.
If needed, adjust the audio level on your source device to keep the average input
level between –30 and –10 dBSF.
Clipping detectors
Peak level indicators
Axio Installation and User Guide.book Page 103 Monday, July 14, 2008 8:00 AM