User guide

89
Defining your General settings
Specifying settings for 5.1 surround mapping (X.linkHD
and X.linkSD)
You can indicate which 5.1 surround channels you want to assign to the audio
outputs from the X.linkHD or X.linkSD breakout box when playing back 5.1
surround tracks in your sequence.
°To specify your 5.1 surround mapping settings:
1 Choose Project > Project Settings > General and click the Playback
Settings
button.
2 Click the Audio Output tab, then click the 5.1 Surround Mapping tab.
¦NoteThe AES/EBU channels are not available on X.linkSD.
3 Under Surround Channels, drag the speaker buttons representing each of
the 5.1 surround channels to the particular output channels to which you
want them to be assigned. For example, to output the front left and right
channels to the analog left and right outputs, drag the button to
Analog L/R.
You can select
Output center/subwoofer to same pair if you want both
the center and subwoofer surround channels to be output to the same stereo
pair (the two channels will be represented as a single button). This setting is
required for some equipment.
4 To mute the output for a particular channel, click its speaker button. To
re-enable the channel, you must assign a surround channel to it.
5 Under SDI, you can assign surround channels to a maximum of four SDI
audio pairs (two pairs from any two groups). To assign a surround channel to
Axio Installation and User Guide.book Page 89 Monday, July 14, 2008 8:00 AM