User guide

Matrox Avio Series – User Guide 19
Connector
TX RX
Description Required host
connection
SFP+ 99Use a Duplex LC-LC fiber optic cable to
connect your Avio transmitter and receiver units
to each other.While a fiber optic cable is
connected to the unit and your unit is plugged
in, the optical connection LED ( ) is active
(green).
USB 2.0 9 Connect your USB devices to this connector.
Note: Your Avio unit only supports up to USB
2.0 connectors.
Main USB
Debug 9 This USB connector is reserved for Matrox
technical support use only.
USB HID 99Connect only your USB HIDs (Human Interface
Devices, such as keyboard and mouse) to this
connector. A maximum of three (3) USB HIDs
can be connected to your receiver unit.
Note: Your Avio unit only supports up to USB
2.0 connectors.
Main USB or
Dedicated USB
links
VGA+DVI SL
*
99Connect your analog (VGA) monitor or digital
(DVI) single-link monitor to this connector.
Monitors attached to this connector on the
transmitter and receiver units use the same
display resolution and monitor settings.
DVI-SL
VGA+DVI SL/DL
*
99Connect your analog (VGA) monitor or digital
(DVI) single-link or dual-link monitor to this
connector.
Monitors attached to this connector on the
transmitter and receiver units use the same
display resolution and monitor settings.
DVI-SL/DL
* While using a dual-link display resolution (such as 2560 x 1600) with the DVI SL/DL and VGA+DVI SL/DL
connectors of your units, the DVI SL and
VGA+DVI SL connectors are disabled.