User`s manual

Version 1.3
Copyright by
CYTECH GmbH 2008
ENG 8 www.indoorcycling.com
8. Reattach the front grub screw
back into the handlebar until the
end of the grub screw (E) almost
touches the hhandlebar post.
Finally, slide the handlebar to the
desired position and retighten the
adjustment knob.
9. Identify the right pedal.
Carefully insert the right pedal into
the crank arm by hand turning it
clockwise, assuring that it is
aligned horizontally. Using a
15mm pedal wrench, firmly tighten
the right pedal clockwise into the
right crank arm. Repeat the same
procedure for the left pedal but in a
counter clockwise motion.
The manufacturer recommends
the use of semi loctite to mount
the pedals and to avoid pedals
becoming loose while riding.
8
9
USER’S MANUAL
–
S
-
SERIES
E
10. Make sure that all parts are
properly tightened and that the
brake pad is thoroughly soaked
with lubricant (WD-40) BEFORE
the indoor cycle is used. Also
make sure there is a space
(approx. as thin as a credit
card) between the brake pad
and flywheel on the lowest
resistance setting. This
precaution will avoid extensive
wear on the brake pad. To
protect the floor or carpet,
place a mat under the indoor
cycle.
10