Service manual

66
1) Turn off power and disconnect the cord from the machine.
2) Remove the console as outlined in Section 9.12.
3) Remove the back cover of the console (Figure A).
4) Unplug and remove the faulty overlay (Figure B).
5) Clean the console area with alcohol to remove any left over adhesive (Figure C).
6) Peel part of the protective film over the display window of the overlay (Figure D).
7) Push the overlay ribbon cable through the hole in the console plastic and plug it into the control board (Figure E).
FIGURE A FIGURE B
9.19 OVERLAY REPLACEMENT
FIGURE C FIGURE D
FIGURE E
CHAPTER 9: PART REPLACEMENT GUIDE