Owner`s manual
20
BEFORE USING THE UNIT PERFORM INITIAL SETUP.
LEVELING THE UNIT
Locate a level, stable surface to position the Stepper. The Stepper has leveling feet located under the
foot support. If your Stepper wobbles in the location where you intended to use it, loosen the lock nut
on the adjusting foot and adjust the feet until stable. Once level, lock the adjusting feet by tightening the
lock nut to the frame.
Our equipment is heavy, use care and additional help if necessary when moving. Failure to follow
these instructions could result in injury.
WARNING
LOCATION OF THE UNIT
Place the unit on a level and stable surface away from direct sunlight. The intense UV light can cause
discoloration on the plastics. Locate your unit in an area with cool temperatures and low humidity. Please
leave a clear zone behind the unit that is at least 24” (600 mm). This zone must be clear of any obstruction
and provide the user a clear exit path from the machine. Do not place the unit in any area that will block
any vent or air openings. The unit should not be located in a garage, covered patio, near water or outdoors.
24” 600 mm