Specifications

Matrix SETU ATA211 System Manual 81
Configuring Peer-to-Peer Calling
To use Peer-to-Peer calling, do the following:
• enable the SIP trunk.
• set the SIP Trunk Mode to Peer-to-Peer.
• configure the number callers must dial to reach this SIP trunk as its SIP ID.
• set the Incoming Call Routing option on the SIP trunk as Route to FXS.
• configure Outgoing Call Route on the FXS port.
• configure Incoming Call Routing on the FXO port.
• configure the Peer-to-Peer table.
If you have not configured the Peer-to-Peer table from the SIP Trunks page under Basic Settings, you may do so
now.
1. Log in as Admin.
2. Click the Advanced Settings link on the left pane to expand.
3. Click the Peer-to-Peer Numbers link. The Peer-to-Peer Table opens.
In the Peer-to-Peer table, each entry is stored against an Index Number from 001 to 500. The first entry at
Index001 is reserved for No Match Found.
4. For each Index number,
• In the Number field, enter the peer-to-peer number string—prefix or entire number—that will be dialed.
The number string must not exceed 24 characters. Default: Blank.