Manualshelf

Specifications

ManualsBrandsMatrix ManualsComputer equipmentSETU ATA211 SIP-FXS-FXO
11121314151617181920
Matrix SETU ATA211 System Manual 13
Configuring SETU ATA211
SETU ATA211 provides access to system configuration at two levels: Admin and User. A distinct set of features
and facilities can be configured at each of these levels.
SETU ATA211 can be configured using its Web-based graphic user interface (GUI) and from the phone connected
to its FXS port. While the entire system configuration can be done using the GUI, you can configure only certain
parameters from the phone.
Admin Mode
Admin is defined as the person who installs, configures and maintains the SETU ATA211. The Admin can also be
the User. In the Admin mode, you have full access to system configuration, all configurable parameters, features
and facilities, and system maintenance:
• Basic Settings
• Advanced Settings
• Supplementary Services
Access to Admin mode is protected by a password. The default Admin Password is 1234. The password may be
changed.
User Mode
In the User mode, you can configure (enable/disable, set/cancel) specific features and facilities of SETU ATA211,
as listed below:
• Supplementary Features
• Speed Dialing
• Network parameters
• User Password
• Syslog (debug)
• Factory Defaults
•PCAP
Access to the User mode is also protected by a password, referred to as the User Password. The default User
Password is 1234. The password may be changed.
Configuration using Web-based GUI: Jeeves
SETU ATA211 has a graphic user interface (GUI), Jeeves, an easy-to-use proprietary software of Matrix for system
configuration. Jeeves is an embedded, web server which you can access from the computer you connected to the
LAN Port or the WAN Port of SETU ATA211.
Jeeves allows system configuration in the Admin mode and User mode.
To access Jeeves, follow these steps:
• Connect a standalone computer to the LAN port of SETU ATA211. The LAN Port of SETU ATA211 and that
of the computer must be in the same Subnet.
The default IP Address of the LAN port of SETU ATA211 is: 192.168.002.006
The default Subnet Mask of the LAN port of SETU ATA211 is: 255.255.255.0