Specifications

Matrix SETU ATA211 System Manual 149
There are two important passwords for the configuration of ATA211 viz Admin Password and User
Password. Admin password protects the access to whole configuration while User password protects the
access to only few configuration of ATA211.
If you forgot the user password but you still have access to admin password, you can login to Web
Jeeves and change the user password. But, if you forgot the admin password, you need to default the
Password using access code '#***' from the Phone, connected to the ATA211.
Refer “Reinstate Factory Defaults” and “Configuring SETU ATA211” for more details.
Q.16 I am not able to access the Web Jeeves since I forgot the IP address of LAN port of ATA211. How can I
know the IP address of LAN port?
Ans. You can use the system commands to know the IP address of LAN/WAN port of ATA211. Please ensure
that you have the SLT (compatible for CLI type) connected to the FXS port.
Q.17 Can I make call to PSTN, GSM number using the FXO port of ATA211?
Ans. Yes. You can make call to any PSTN, GSM number using the FXO port of ATA211. You need to select the
FXO port by the command for 'Selective Trunk Access - FXO', #83 followed by the number to be dialed.
You can also do this by configuring the 'Outgoing Call Route' to 'FXO' in the Web page 'FXS Port', before
dialing the desired number or by setting 'Dialed Number Based Routing'.
Q.18 Incoming calls on FXO port of ATA211 does not place on FXS port. Why?
Ans. Please check the destination route configured in Webpage 'FXO Port'.
Q.19 Can I change the configuration of ATA211 to factory default?
Ans. Yes. You can change the configuration to factory default. Refer “Reinstate Factory Defaults” for
this information.
Q.20 Can I select the SIP Trunk or FXO port to make OG call?
Ans. Yes. You can dial first the access code for the FXO, SIP1, SIP2 or SIP3 and then dial the required
number for OG call.
Q.21 Can I use the ATA211 for Least Cost Routing (LCR) application?
Ans. Yes. You can do this by selecting 'Dialed Number based Routing' for parameter 'OG Call Route' in Web
page for 'FXS Port' . After selecting option for routing, program in the Webpage 'Dialed Number Table', the
numbers to be dialed and corresponding SIP Trunk or FXO port as Destination Route which is cheaper
for the call to be made.
Q.22 Can I route the Incoming calls on SIP to FXO?
Ans. Yes. You can configure suitable routing option for 'Route the Incoming Calls' in the Webpage 'SIP Trunk'.
Refer “SIP Trunks”.