Specifications

130 Matrix SETU ATA211 System Manual
Configuring Multi-Stage Dialing
For this feature to work, at each site where the SETU ATA211 is installed, do the following:
• Make sure that Auto Attendant or Direct Inward Dialing is enabled on the FXO port of the PBX on which
SETU ATA211 is interfaced.
• Enable Automatic Number Translation on the desired SIP Trunk of SETU ATA211.
• Configure the Automatic Number Translation Table.
• Set the DTMF ON Time, DTMF OFF Time.
• Enable ‘Play Routing Tone’ in the System Parameters, if required.
• Set the Pause Timer to the desired value.
To configure Multistage Dialing at each site where the SETU ATA211 is connected,
• Open Jeeves.
• Log in as Admin with your password.
• Click the Basic Settings link.
• Under Basic Settings, click SIP.
• Now, click the SIP Trunk number tab (SIP Trunk 1, 2, or 3) on which you want to apply Multi-stage Dialing.
• Click the More button to view all parameters on this page.
• Scroll to Advanced.
• Enable Automatic Number Translation on this SIP Trunk.
• To configure the Automatic Number Translation Table, click the arrow icon.