Product manual

Page | 5
Step 7:
a) Reverse the Aluminum Beam Extrusion
(001) to the rear.
b) Assemble the Leg and Stabilizer (007) and
the Aluminum Beam Extrusion (001) with 4
bolts (300) and 4 washers (401).
c) Secure the Rear Bracket (009) with 2 bolts
(302).
Step 8:
a) Remove the Safety Strap Holder and
discard.
b) Tilt forward the Main Frame (002) as shown
in the diagram below.
c) Assemble the Stabilizer Tube-Front (005)
with 2 bolts (305) and 2 washers (405).
Step 9:
Assemble the Stabilizer Tube-Middle (006) and
Main Frame (002) with 2 bolts (304) and 2
washers (405), 2 nuts (205) and 2 washers
(405).
Step 10:
a) Slide the Foot Pedal Bar (012) through Main
Frame (002) as shown in the diagram below.
b) Assemble the Left and Right Foot Pedal
(108) and Foot Pedal Bar (012) with 2 nuts
(202) and 2 washers (401).
Step 11:
a) Remove 6 bolts (300) and 6 washers (401).
b) Assemble the Aluminum Beam Extrusion
(001) with the same 6 bolts and washers,
then tighten firmly.
c) Press the pop pins on the sides to connect
the computer arm cables to the computer.