Owner`s manual

1110
LOCATION OF THE EXERCISE BIKE
Place the unit on a level and stable surface away from direct sunlight. The intense
UV light can cause discoloration on the plastics. Locate your unit in an area with cool
temperatures and low humidity. Please leave a clear zone on both sides of the unit
that is at least 24” (600 mm). This zone must be clear of any obstruction and provide
the user a clear exit path from the machine. Do not place the unit in any area that will
block any vent or air openings. The unit should not be located in a garage, covered
patio, near water or outdoors.
MOVING THE UNIT
Two hand holds are located just above the MATRIX logo on the rear legs of the unit. To
avoid injury to the user or the unit, be sure to have proper assistance to move the unit.
LEVELING THE EXERCISE BIKE
Locate a level, stable surface to position the Cycle. The Cycle has leveling feet
located under the foot support and the center of the frame. If your Cycle wobbles in
the location where you intended to use it, loosen the lock nut to the adjusting foot and
adjust the feet until stable. Once level, lock the adjusting feet by tightening the lock
nut to the frame.
USING THE HEART RATE FUNCTION
Your exercise bike is equipped with heart rate pulse grips.
The heart rate function on this product is not a medical device. While heart rate grips can provide a relative estimation of
your actual heart rate, they should not be relied on when accurate readings are necessary. Some people, including those in
a cardiac rehab program, may benefit from using an alternate heart rate monitoring system like a chest or wrist strap. Various
factors, including movement of the user, may affect the accuracy of your heart rate reading. The heart rate reading is intended
only as an exercise aid in determining heart rate trends in general. Please consult your physician.
Never operate product if it has a damaged cord or plug, if it is not working properly, if it has been damaged, or immersed in
water. Contact Customer Tech Support for examination and repair.
POWER
Your exercise bike may be powered by a power supply. The power must be plugged into the power jack, which is located in the front
of the machine near the stabilizer tube. Unplug cord when not in use.
UPRIGHT SEAT HEIGHT
To adjust the seat height on the Upright Cycle, locate the orange pull pin before you mount the Cycle. To raise or lower the seat, pull
the orange knob while holding the seat with the other hand and slide up or down accordingly. Make sure you are not seated when
you pull the knob or pull the seat up.
The seat height adjusts from level 1 to 15, when you see the mark “15 MAX” on the seat post, stop to pull the seat up.
WARNING
Our equipment is heavy, use care
and additional help if necessary
when moving. Failure to follow these
instructions could result in injury.
WARNING
24”
600
mm
24”
600
mm
24”
600
mm
HYBRID SEAT HEIGHT
To adjust the seat height on the Hybrid Cycle,
pull the orange lever under the seat and lower
the seat to the lowest position, stand over the
seat and grab the orange lever. Pull the lever
and lift until the seat base makes contact with
your pelvic bone.
RECUMBENT SEAT HEIGHT
To adjust the seat height on the Recumbent Cycle, locate the yellow lever under
the right side of the seat before you mount the Cycle. Place your right hand on
the orange adjustment handle under the right side of the seat. Place feet on the
ground while seated and slide forward if needed. Place feet on pedals, gently lift
lever under the right side of the seat. Using legs, slowly push and slide the seat
up or down to desired position. Release lever and allow to lock into place.
MX_12_HUR3x_5x_7xe_OM_Rev1_3.indd 10-11 10/25/12 8:36 AM