Specifications

56
CHAPTER 9: PART REPLACEMENT GUIDE
9.19 BLOWER MOTOR REMOVAL
1) Unplug treadmill.
2) Remove console as outlined in Section 9.12.
3) Lay console face down and remove four screws using a Phillips screwdriver (Figure A).
4) Console shell will now separate. Unplug the wire connections from the main circuit board to completely split the front and rear sections (Figure B).
5) Use a Phillips screwdriver to remove two screws and washers holding the blower motor in place (Figure C).
6) Carefully separate blower motor from duct and connect new motor. (Figure E).
7) Reinstall screws and washers, connect wires to main board, and reassemble console halves.
8) Be sure to test blower motor once console is reinstalled.
FIGURE A
FIGURE B
FIGURE C
FIGURE D