Specifications

54
9.17 EMERGENCY STOP SWITCH REPLACEMENT
CHAPTER 9: PART REPLACEMENT GUIDE
1) Unplug treadmill.
2) Use a Phillips screwdriver to remove two screws, one from each side of the red button (Figure A).
3) Lift button from bracket by pulling one side our at a time (Figure B).
4) Use A Phillips screwdriver to remove two screws, one from each side of the mounting bracket (Figure C).
5) Turn bracket and use a straight screwdriver or pliers to compress each end of the switch and release it from the bracket (Figures D & E).
6) Make sure new switch has the same orientation as the old one when installing, and wires are properly connected.
FIGURE A
FIGURE B
FIGURE C
FIGURE D
FIGURE E