Specifications

42
CHAPTER 9: PART REPLACEMENT GUIDE
9.8 MOTOR CONTROL BOARD REMOVAL (MCB)
1) Unplug treadmill.
2) Remove front shroud as outlined in Section 9.1.
3) Cut any wire ties that are secured to the MCB panel (Figure A).
4) Disconnect wires from the MCB - seven total connections (Figure B).
5) Remove two MCB mounting screws using a Phillips head screwdriver (Figures C & D).
6) Auto Calibration must ALWAYS be run after replacing the MCB.
FIGURE A
FIGURE B
FIGURE C
FIGURE D