Specifications

25
8.5 ERROR MESSAGE TROUBLESHOOTING
ERROR MESSAGES  0x01A2, 0x01A0, 0x0140, and 0x01A1.
1) CAUSE - Elevation Direction is reversed.
2) SOLUTION:
a. Check that the elevation motor cable is connected at the MCB.
b. Press and hold ELEVATION DOWN and SPEED DOWN at the same time for 3-5 seconds. The display should now read Manager Mode.
c. Press any UP arrow key to go to Engineering Mode and press ENTER.
d. Press any UP or DOWN arrow keys until Auto Calibration is showing on the display, press ENTER. If unit passes auto calibration, delete error log,
unit is operational.
e. IF AUTO CALIBRATION FAILS, press any UP or DOWN arrow keys until Elevation Minimum is shown on the display and press ENTER (Figure A).
f. Check to see if the LED UP and DOWN lights are lit on the MCB. If LEDs are not lit, check the console cable and console. If LEDs are lit, replace the
elevation motor (Figure B).
g. If elevation motor does not resolve issues, replace MCB.
FIGURE A
FIGURE B
CHAPTER 8: TROUBLESHOOTING